Puffy PE 20

PUFFY PE 20 (soft) 3мм.

Truly Outstanding Embroidery Effects!

Bulky, raised monograms, three-dimensional patterns – embroideries made with PUFFY will stun everyone! For creating the enhanced 3D effect. The embroidery design is simply satin-stitched over the foam, giving caps, promotion wear and outerwear a completely new touch.

Available in 2 densities:

• PE 20: soft, highly suitable for outerwear 
• PE 10: harder, for caps and logos

PUFFY - Embroidery Foam for Three-Dimensional Effects

• Place PUFFY on the fabric to be embroidered and attach it with adhesive spray KK, if needed. u Satin-stitch your design. The machine needle perforates the foam during stitching.
• A double stitch density instead of the standard setting is essential for completely covering and encasing PUFFY during stitching. u Use satin stitches, not fill stitches. The wider the satin stitch, the stronger the 3D effect will be achieved! Step stitches will destroy the foam.
• A needle with SES point will perforate PUFFY better than needles with sharp points.

Tip: A standard 75 needle usually produces good results. If the foam is visible despite correct digitization, select a 60 needle with SES tip or remove the foam particles with a hot air blower.

• An extremely strong 3D effect can be achieved by using two layers of PUFFY on the base fabric. If needed, bond it with an adhesive spray.